Had A Flood? Where You Should Look For Mold And How To Get It Out

If you recently had a flood in your home, you need to look for mold once you get everything back in order again. This is because mold can grow on anything that is damp or wet. Once it starts growing, mold can then spread quickly. To help you, below are places you should look for mold, as well as how to get it out of your home.

Find Mold

The first place to look is where the flood happened. For example, if the flood was due to burst pipes in the bathroom, look for mold on the walls, ceiling, and floor. Mold may be black, but it can also be a lighter grey or white color. 

If you had a flooded basement, look for mold around where the flood started. Mold can quickly grow in a basement because it is damper than a room that is used much more, such as a bathroom. The mold can grow on anything in the basement, such as furniture, duct work, or pipes. If the flood started in the basement and you have HVAC duct work that runs through this room, mold can get inside the duct work. If this happens, mold spores will spread throughout your home each time your HVAC unit runs. 

If the flood was very bad, there may be mold where you are not able to see it, such as inside the walls, in the attic, and more.

Remove Mold

If you do not have a lot of mold, you can get rid of it on your own. First use a rag to remove the mold. Next, fill a spray bottle with half water and half bleach. Spray the solution on the mold and leave it on for 15 to 20 minutes. The bleach solution will kill any mold spores that are left behind. This is important as if there are mold spores the will easily grow back again. Wipe the bleach off the area. You can purchase a product at a home improvement store that will help prevent the mold from coming back. This product is sprayed over the area and then left on. 

If you have a lot of mold in your home, hire a mold removal company. This company has the equipment needed to completely get the mold out of your home. They will first seal up the room where the mold is found to prevent it from spreading. This company can use things like chemicals, mold detectors, and vacuums in order to get the mold out. 

The mold removal company may have to scrape off paint or remove drywall. They may also have to pull up flooring in order to find the mold. When they are finished, they will repair any damage they had to make. They will also use a special product to prevent the mold from coming back again. 

Talk with the mold removal company that you hire, and they can give you much more information. Visit a site like http://www.colfaxcorp.net to learn more.


Share